Dirt, dust, and fingerprint smudges aren't going to do any long-term damage to your monitor, but they certainly might distract you while trying to headshot Tracer in Overwatch. Let's face it, your monitor is filthy—it's time to clean it.
You might think that cleaning your monitor is easy, and you're right. But the process is slightly more complicated than just wiping it with the corner of your t-shirt—or even worse, a paper towel. Here are a few do's and don'ts:
How not to damage your monitor
PC Gamer is going back to the basics with a series of guides, how-tos, and deep dives into PC gaming's core concepts that we're calling The Complete Guide to PC Gaming. There's much more to come, and it's all being made possible by Razer, which stepped up to support this months-long project. Thanks, Razer!
Before we start, let's go over a few big no-no's, as accidentally damaging your monitor is a pricey mistake we want to avoid.
First off, avoid corrosive substances! That means no alcohol- or ammonia-based cleaners (like diluted rubbing alcohol or Windex). These cleaners can damage your screen by stripping anti-reflective coatings, cause clouding, or worse. Monitors have come a long way from the giant glass bulbs of old-school CRT screens, but that means they're a lot more sensitive too.
Next, be careful what you use to wipe the screen. Paper towels might seem like a good option, but at a microscopic level, they're actually quite abrasive. Ditto to t-shirts or other household rags, which might be harboring a stowaway spec of sand, metal, or something else that could scratch up your display in a single wipe.
Finally, you never want to spray your cleaning agent directly onto your monitor. Excess liquid runs the risk of pooling in the corner of your screen, seeping in through tiny weak spots and wreaking havoc on the sensitive materials inside.
How to clean your PC monitor
With those words of warning aside, let's get down to the business of cleaning that monitor. For simple dustings, a blast of compressed air (the same stuff you use to knock dust out of your case fans) should do the trick, possibly followed up by a quick dry wipe-down.
As for what you wipe with, microfiber cloth is your best friend. Microfiber is extremely soft (at a microscopic level) and known for attracting dust and absorbing oils. Most importantly, it won't damage your screen. We like these, or these if you want to step up to a more plush option.
Of course, make sure the cloth is clean before you use it, and be particularly careful of any grit getting on the fibers. A single speck of dirt or sand could do more harm than all your careful preparation. Depending on your environment, you might be able to use the same cloth for weeks, or it might need to be swapped out after just a few uses.
For a little bit of extra cleaning power, slightly dampen your cloth with distilled water (no impurities to cause accidental damage), but not so much that water can be wrung out of it. Remember, we don't want liquid to run down the screen and collect in the edges and corners. If water alone isn't doing the trick, mix a cleaning solution of 50 percent distilled water, 50 percent white household vinegar. Same deal as before—apply liquid to the cloth, not the screen.
When wiping your screen, try to avoid circular motions or buffing a single particular spot. Instead, use light pressure and wide, sweeping motions from side to side or top to bottom. It might seem trivial, but again these are sensitive electronics we're cleaning, and better to be mindful of your technique than buff in a costly repair.