Thread: NZXT Screw HARD
View Single Post
  #4   Report Post  
Old 03-01-2012, 11:06 AM
Belimawr Belimawr is offline
Senior Member
 
Join Date: Jun 2010
Posts: 14,251
Default

sorry for the slow reply I had actually been posting from my phone, there is also the chance if it isn't glue that what ever tool they have used for the self tappers has went too fast and melted in place, there are any number of stupid reasons it could of happened, but you can't really over tighten into plastic without trashing the hole as the thread you make in the hole is really weak.

if the screws have a decent head and you have a tool that will let you use a screw driver bit as a wrench shocking them (a short quick knock) could break the bond if they are melted in place or such, but you obviously have to be sure of the screw head holding up.
Reply With Quote